TEC 800-S REMOTE IRRIGATION MODULE

Process Steps and Considerations

1) Remove the PIN code of the Sim Card you bought from any GSM operator. You can do this with your phone.

2) Make the service settings. To be sure, call another device, send and receive text messages(sms).

3) Before turning on the device, insert the antenna and the SIM card into the device correctly. Settings and phone operations related to the device are carried out by sending an SMS to the SIM card inserted in the device. As shown in the examples, desired settings can be made by sending SMS messages. In fact, when there is no money left, you will not receive a message back as a result of the SMS, but the commands will work and the message of the transaction will appear on the screen.

4) Factory setting: All relays are off.

5) When the electricity is cut off and comes back on (if the device is connected to battery power supply), this situation is notified by sms. When the power returns, all relays turn off. If a program is loaded, the relays are activated according to that program.

6) Adjusting the relays can be done in 3 ways. Voice response system, one-command operations via sms and weekly programming. Of these three, the priority is the weekly programming. For example, if the relay1 component is set to remain open until 11:00 in the weekly program, our device will activate the relay by looking at the program again after 15 seconds, even if we say ""turn off role1"" via sms. If the role is to be closed in these situations, the relevant program must be deleted.

7) Voice response system: When the call is made, depending on the status of the relays, if it is open, for example, ""press one to close relay 1"", if it is closed, for example, ""press three to open relay 3"", it will give voice information. When the relevant number is keyed, it performs the specified operation. If desired, other relays can be adjusted in the same way without turning off the phone. If 0 (zero) is pressed, all relays are turned off. (Note: If there is no program set for the current time)